Add Grid proportion in 3D view

[reporter]

Hi

It would be great if you could modify the 3d grid to more accurately represent the view particular installation.

In my instance, I have just installed a grid of tubes 9 x 18 x 16 pixels, but physically, the dimensions are 3.25m x 6.9m x 1m. To complicate things further, I'm using tubes which have two pixels vertically,

There's already a similar functionality to adjust the view of the 2d preview. If that were extended to 3d previews also, it would be a good start.

Thanks,

Nathan

[Wissmann]

Hi Nathan,

thank you for the hint.
We already work on it, but it will still nedd some time.

[E.Kirby]

I found you can replicate this somewhat (but not perfectly) by using the offset when you setup the matrix.

[Wissmann]

Yes, but this increase the patch size, which could cause a Performance issue, depending on the total patch size.
However from time to time i use this posibility as well.